Northern Industrial Tools 1961202 Manuale Utente Scaricare il pdf (Pagina 3)

Fig. 1

2 of 4

10.Use compressed air only. Clean, dry, regulated compressed air at 90 PSI. Never use

oxygen, carbon dioxide, combustible gases, or any other bottled gas as a power source

for this tool.

11.Always disconnect air supply when this tool is not being used.

NOTE: The warnings, cautions, and instructions discussed in this instruction manual

cannot cover all possible conditions and situations that may occur. It must be

understood by the operator that common sense and caution are factors that cannot

be built into this product but must be supplied by the operator.

NOTE: READ ALL INSTRUCTIONS BEFORE USING THIS PRODUCT

OPERATION

Set Up

WARNING!

This impact wrench supplies powerful torque and it designed to be operated with two

hands. Failure to operate the Impact wrench with two hands may result in serious

injury.

1.You will need to prepare a 1/4" air connector (not included) to connect to the air

inlet on the tool. First, wrap the 1/4" air connector with pipe thread seal tape (not

included) before threading it into the inlet. Connect the 3/8" ID air source hose (not

included) to a quick-disconnect coupler (not included) and then to the tool.

2.Set the air pressure on your compressor to 90 PSI. Do not exceed the recommended

air pressure of 90 PSI.

3.Check the air connection for leaks.

4.Disconnect from the air hose until next instructed to reconnect.

Note: Turn off your air compressor and disconnect the air hose when you are changing

sockets. After you attach the socket (not included), attach the air hose and turn the air

compressor on.

i.Select the appropriate size 1/2" socket for your needs.

ii.Push and snap the socket onto the anvil.

iii.Tightening

The max. working torque of the impact wrench is 300ft.-lbs. It can be adjusted from

115 ft.-lbs. to 300ft.-lbs. Make sure that the nut or bolt you are using the tool to tighten

can withstand the rated torque.

1 2 3 4 5

Nessun commento

Northern Industrial Tools 1961202 Manuale Utente Pagina 3